Table of Contents
Advertisement
8.10 Switch bracket
Refer to Figure 13.
Remove existing screw and washers from the
farthest left hole on the guide tube, and use
them to secure the control switch to bottom of
guide tube, as shown in Figure 13 (10mm
wrench).
Figure 13
8.11 Motor cover
Refer to Figure 14.
1. At the motor side, slide the hinge pins of the
motor cover down into the cylinders.
2. To secure cover, loosen knob (B), and swing
cover shut, while pushing in on the side. The
slot (C) should slide beneath the knob.
3. Tighten knob (B).
Figure 14
8.12 Table insert
Refer to Figure 15.
Place insert into table opening (the finger hole is
toward front of saw). Verify that insert lies flush
with table surface by resting a straight edge
across it at various points. If insert is not flush
along its length, turn any of six set screws (D) to
raise or lower that area of the insert.
NOTE: If while lowering blade, the points on the
anti-kickback pawls tend to catch in the seam
between table and table insert, slightly raise that
area of the table insert above main table
surface.
8.13 Installing and removing blade
A blade is not provided with the 64B.
1. Using front handwheel, raise blade arbor
fully and tighten lock knob.
Refer to Figures 16 and 17.
2. Remove nut (A) and flange (B), and install
blade onto arbor, making sure the teeth
point downward toward front of saw.
3. Install flange (B) and nut (A).
4. Rotate arbor until hole (C, Figure 17) aligns
with arbor lock pin (D). Push tab (E) to seat
pin into hole, and hold to prevent blade
rotation.
5. Tighten nut (A) with arbor wrench.
6. Release arbor lock (E).
15
Figure 15
Figure 16
Hide quick links:
Advertisement
Table of Contents
