Rails And Fence; Switch Bracket; Wood Extension Table; Motor Cover - Powermatic PM1000T Operating Instructions And Parts Manual

Level table extensions to saw table using a straight
edge. A metal straight edge is ideal, though a
carefully jointed board may also be used.
Figure 6
1. Shift table extension so it is slightly above saw
table surface.
2. Begin by tightening the three screws (17mm
wrench) under the table extension that secure
it to saw table. Tighten these just enough to
hold extension in place but loose enough to
change the extension height by tapping on it.
3. Lay straight edge (Figure 6) across saw table
and table extension, extending it out past edge
of the extension as shown.
4. Move straight edge to several places along the
table extension, as you continue to nudge the
extension level with saw table. As each area of
table extension becomes flush with table,
tighten the screw under that area. Continue
until all three screws are fully tightened.
NOTE: Make sure front edge of table
extension remains flush with front edge of saw
table.
5. Repeat above steps
extension.

7.7 Rails and Fence

With table extensions properly aligned, the rails
®
and Accu-Fence assembly can now be mounted
to saw. Consult manual no. M-2195075Z, that
accompanies the fence.
NOTE: The switch bracket must be mounted to
front rail before installing guide tube. Follow
instructions in section 7.8, then install guide tube.

7.8 Switch Bracket

Refer to Figure 7.
After front rail has been installed, mount switch
bracket with three flat head screws (HP-7).
Mount guide tube to front rail, referring to
instructions in your Accu-Fence manual.
for opposite table
12
Figure 7

7.9 Wood Extension Table

For instructions on mounting the accessory wood
extension table, consult Accu-Fence manual,
document no. M-2195075Z.

7.10 Motor Cover

Refer to Figure 8.
At the motor side, slide hinge pins through motor
cover cylinders and into hinge barrels on saw.
Close motor cover until it catches on latch post on
saw.
Note: The catch mechanism may require slight
adjustment to ensure proper alignment.
Figure 8
7.11 Table Insert
Refer to Figure 9.
Model
industrial-grade low-friction corrosion-resistant
coating on the table and table extensions.
While the coating is durable, it can be damaged
if metal or other hard and/or sharp objects
strike, gouge, or
Significant damage to the coating may affect its
performance. Use care when using a metal
straight edge to verify insert is flush with the
table surface.
PM1000T has an
scratch the surface.