Motorola FR68 Series User Manual page 126

Table 9-1
Problem
FR68 Series shuts
off.
Tapping the
window buttons or
icons does not
activate the
corresponding
feature.
A message
appears stating
that the FR68
Series memory is
full.
FR68 Series
keeps powering
down to protect
memory contents.
The FR68
Series does not
accept scan
input.
Troubleshooting the FR68 Series (Continued)
Cause
Battery is
over-temperature.
Screen is not calibrated
correctly.
Too many files stored on
the FR68 Series.
Too many
applications
installed on the
FR68 Series.
The FR68 Series'
battery is low.
The internal Bluetooth
radio is powered on
for a long time.
Scanning application
is not loaded.
Unreadable bar
code.
Distance between exit
window and bar code is
incorrect.
FR68 Series is not
programmed for the bar
code.
FR68 Series is not
programmed to
generate a beep.
Battery is low.
Maintenance & Troubleshooting
Solution
Battery temperature >40℃(
Re-calibrate the screen. See
Page 20.
Delete unused memos and records. If necessary,
save these records on the host computer (or use an
SD card for additional memory).
Remove user-installed applications on the FR68 Series to
recover memory. Select
Remove Programs
and tap the
program and tap Remove.
Recharge the battery.
Because this mode requires battery power, power it off
when not needed.
Load a scanning application on the FR68 Series.
See the system administrator.
Ensure the symbol is not defaced.
Place the FR68 Series within proper scanning range.
Program the FR68 Series to accept the type of bar code
being scanned.
If the FR68 Series does not beep on a good decode, set
the application to generate a beep on good decode.
If the scanner stops emitting a laser beam upon a trigger
press, check the battery level. When the battery is low,
the scanner shuts off before the FR68 Series low battery
condition notification. Note: If the scanner is still not
reading symbols, contact the distributor or Motorola.
124
104°F ) or <-10℃ (14°F)
Calibrating the Screen on
>
Start Settings System
> tab
icon. Select the unused