Cam Riser, Door Closure, Handle - GE Profile TNX22P Technical Service Manual

Transfer Top Hinge to the Left
1. Position the top hinge over the screw holes in the top
left of the cabinet, ensuring that it is lined up with the
other two hinges.
2. Put the Torx screws two or three threads into the holes
that were not used when the hinge was on the was on the
other side, DO NOT tighten at this time.
Remove Door Stops, Cam Riser, and Cam
Closure
1. Remove the left hand door stops and cam closure from
the reversibility kit. The reversibility kit is taped onto the
bottom shelf of the fresh food door.
2. From the freezer door, remove the door stop, along with
the cam riser, spacer shims, and aluminum foil from the
right side of the bottom flange, using a T-20 Torx driver.
3. From the fresh food door, remove the door stop, along
with the cam closure, spacer shims, and aluminum foil
from the right side of the bottom flange using the T-20
Torx driver.
4. The door stops and cam closure on the right side can
be placed in the reversibility kit bag, and the rest of the
parts can be put aside, along with the new left hand cam
closure and door stop.
Transfer Freezer Door Handle
1. Remove the screws holding the handle to the top and
bottom of door.
2. Remove the foam hole plug and plug buttons, and
reinsert them on the right side.
3. Reattach the handle on the opposite side.
CAUTION: Be careful not to scratch the door when
removing and replacing the handle. The handle fits tightly
on the door.
REHANGING THE FRESH FOOD DOOR
1. Lower the fresh food door onto the bottom hinge pin.
(be sure washer is in place)
2. Straighten the door and line it up with middle hinge
bracket.
3. Reinstall the hinge pin with a 7/16" socket, tightening it
flush to the bracket.
TOP HINGE
MIDDLE HINGE BRACKET
22
CAM RISER