Applying Factory Default Values - Raymarine 45STV User Manual

• NO to return to the ANT GO POSITION? screen.
Setting antenna move step
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the PREV soft key four times to display the ANT MOVE
STEP? screen.
3. Press YES to display the STEP AZ control screen.
4. Use the CCW or CW soft keys to step the antenna
counter-clockwise or clockwise, to the required horizontal
direction. The horizontal angle is displayed on the top line.
5. When you have set the required horizontal direction, press the
EL soft key to display the STEP EL control screen.
6. Use the DOWN or UP soft keys to step the antenna, to the
required horizontal direction. The vertical angle is displayed on
the top line.
7. To leave the antenna move step mode, press the EXIT soft key
to return to the ANT MOVE STEP? screen.
36

3.4 Applying factory default values

If you want to return all 45STV settings to the factory default values,
us the following procedure:
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the PREV soft key once times to display the SET
DEFAULT? screen.
3. Press YES.
The message DEFAULT SETTING is displayed and the
parameter values are reset. When the procedure is complete,
the SETUP MODE? entry screen is displayed.
4. Press either:
• YES if you want to change the setup values, or
• NO to re-initialize the system using the default settings.
Raymarine Satellite TV Systems User's Guide