Raymarine 45STV User Manual page 32

– ONLY 13 V - always supply 13 V to LNB.
– ONLY 18 V - always supply 18 V to LNB.
• The required method of Digital Satellite Equipment Control
(DiSEqC). The options are:
– AUTO - change signal to LNB by the IRD DiSEqC. This is the
RECOMMENDED SETTING.
– ONLY 0 KHZ - always supply 0 kHz to LNB.
– ONLY 22KHZ - always supply 22 kHz to LNB.
Procedure
To edit satellite information, start with normal operating information
displayed on the ACU, then at the ACU:
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the NEXT soft key twice to display the EDIT SAT INFO?
screen.
3. Press YES to enter the edit mode.
A satellite name edit screen is displayed.
4. Use the PREV or NEXT soft key to scroll to the name of the
satellite you want to change.
5. To edit the displayed satellite name, press the SELECT soft key.
An edit screen is displayed.
6. Change the displayed name as follows:
i. Use the + and - soft keys to change the value of the character
above the cursor (underscore).
ii. Press the INPUT soft key to accept each correct character
and move the cursor to the next character.
iii. Repeat sub-steps a, b and c until the correct name has been
entered.
7. Press the ENTER soft key to confirm the edited data and display
the edit screen for the next parameter.
32
8. Using a procedure similar to that in steps 2 to 7 above, edit the
other satellite parameters as required. The editable parameters
are typically, in sequence:
• LONGITUDE
• VER LOW/RHCP
• VER LOW NID.
• HOR LOW/LHCP
• HOR LOW NID
• VER HIGH
• VER HIGH NID
• HOR HIGH
• HOR HIGH NID
Press the ENTER button to accept the HOR HIGH NID value,
and display the VERIFY screen.
9. If necessary, use the PREV or NEXT soft key to select the
required method for verifying satellite tracking.
10. Press the ENTER button to accept the VERIFY method and
display the VOLTAGE screen.
11. If necessary, use the PREV or NEXT soft key to select the
required method of supplying power to the LNB.
12. Press the ENTER button to accept the VOLTAGE method and
display the DISEQC screen.
13. If necessary, use the PREV or NEXT soft key to select the
required method of Digital Satellite Equipment Control (DiSEqC).
The options are:
i. AUTO
ii. 0KHz
iii. 22KHz
14. Press the ENTER soft key to accept the DISEQC method and
display the SAVE? screen.
Raymarine Satellite TV Systems User's Guide