Jacuzzi J - 415 Owner's Manual page 27

Water Fill Volume by Model
Model
J415 .................................. 202 Gal (765 L) ................................... 5.0 oz
J425 .................................292 Gal (1,105 L) ................................. 7.5 oz
J-460................................350 Gal (1,325 L) ................................. 9.0 oz
J-465................................380 Gal (1,438 L) ................................. 9.5 oz
J-470................................415 Gal (1,571 L) ................................ 10.5 oz
J-480................................480 Gal (1,817 L) ................................ 12.0 oz
J495 .................................520 Gal (1,968 L) ................................ 13.0 oz
*Use average fill volume for chemical maintenance
2. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting
pillows and plastic knobs from chemical attack. If spa is
indoors, open doors and windows for proper ventilation.
Turn on all spa jet pumps for one hour, open all air
controls, and place all massage selector knob(s) in their center
"combo" position as shown.
Note: You will need to activate the jet pumps every 20 minutes since
these functions have an automatic 20 minute time-out that turns them off.
WARNING:
!
• To decrease the risk of injury, drowning or entrapment,
never leave your hot tub unattended for any reason while
the cover is open and accessible, especially to small chil-
dren and animals!
• Precautions should be taken to minimize your exposure
to chemical vapors (that could cause lung, brain, or skin
damage).
3. Turn off power to the spa at the circuit breaker, then drain tub as
outlined in Section 15.2 (page 83).
4. Refill spa with clean tap water from garden hose until water covers
all jets but does not touch the bottom of the lowest headrest with all
headrests in their lowest position (DO NOT OVERFILL!)
CAUTION: to DeCrease builD uP on CoMPonents anD
MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard", it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
Average
Fill Volume*
RISK OF PERSONAL INJURY!
J-400
Sodium
Dichlor
B C
A
Page 21