Jacuzzi J - 415 Owner's Manual page 26

J-400
Important Heater Details:
• The maximum temperature for which the spa can be set is 104°F
(40°C) and the minimum is 80°F (27°C).
• For North American spas: With a 50 amp service, turn off one
of the jet pumps to operate heater. With a 30 amp service, turn
off both jet pumps to operate heater. With a 60 amp service, the
heater will operate with both jet pumps on.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches 1 degree above the
programmed "set temperature", then turns off. The heater will
reactivate after the water cools to approximately 1 degree below
the "set temperature."
8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER:
Check water temperature carefully before entering hot tub!
!
Excessive water temperature can cause burns, welts and body
temperature to rise, hyperthermia (over-heating).
Decontamination Procedure
Steps 1-7 below are only required when sanitizer levels are unstable
after performing Spa Fill Up Procedures steps 1-6. Disregard steps 1-7
below if sanitizer levels remain stable after performing steps 1-6 above
(refer to the inside cover of the manual).
1. Add 2.5 ounces of sodium dichlor for every 100 gallons of water.
Refer to the table below for approximate water fill volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
!
Never add chlorine tablets (trichlor) or acid to your hot tub for
any reason! These chemicals may damage components within
your hot tub, burn or irritate your skin, create a rash, and void
the manufacturer warranty for your spa.
Page 20
RISK OF PERSONAL INJURY.