Replacing the blades
•
Put the unit in the service position, see Service position
for the cutting unit.
•
Remove the equipment frame.
•
Lock the blade with a wooden block. Loosen the blade bolt
and remove the blade bolt, the washer and the blade.
•
Assemble the parts in the reverse order.
•
Tightening torque 45-50 Nm (4.5-5 kpm/32-36 lbft).
15mm
WARNING!
!
Always use genuine parts.
Maintenance
Removing the Mulching plug
To change a Combi deck from the Mulching function to a
cutting deck with rear ejection, remove the Mulching plug,
which is located under the unit, attached with a screws.
1 Put the unit in the service position, see Service position
for the cutting unit.
2 Loosen the screw holding the plug and remove it.
3 Fit cutting unit.
4 Fit the Mulching plug in the reverse order.
– 23
English