Fitting The Cutting Head - Jonsered Frontrider FR2315 MA Operator's Manual

7 Lift of the drive belt.
8 Grip the top tubular construction of the unit and pull out
the unit until it stops.
9 Make sure the lock is in upright position.
10 Remove the pin in the equipment frame.
11 Loosen the stay from the cutting deck.
Pull out the cutting unit.
12 Lift off the deck and lean it against the machine or a wall.
Maintenance

Fitting the cutting head

1 Make sure the lock is in upright position.
2 Place the belt under the stay of the cutting deck.
Make sure the lifting lever comes above the cutting deck grip.
3 Push the cutting deck in and make sure the guide bolts fit
into the grooves on the deck frame, one on each side.
4 Fit the cutting deck's pipe together with the deck frame's
pipe.
5 Grip the front edge of the deck and slide it in.
– 21
English