Starting - BLADEZ MOBY X Product Handbook

fuel is well mixed by shaking the
container.
5. Make sure that the engine is OFF while
fuelling.
6. Slowly open the GAS CAP, so that
possible over-pressure disappears.
7. Clean the tank cap area to make sure
that it is free from excess dirt and debris.
* Make sure that no dirt falls into the gas
tank.
8. Pour pre-mixed Gas/Oil mixture into the
GAS TANK. * Do not overfill.
9. After fueling, replace the GAS CAP and
tighten.

Starting

Move at least 10 feet away from where
you filled up the gas.
10. Push on the bladder (Primer Bulb)
several times to draw gas into the
engine. (Fig. 4)
11. Set the CHOKE LEVER to the CHOKED
(UP) position. (Fig. 5)
12. Pull the RECOIL STARTER briskly,
making sure to hold the handle in your
grasp. (Fig. 6) * Note: Do not allow it to
snap back, let it back slowly. You may
want to give it a little throttle by gently
squeezing the GAS LEVER.
13. It may be necessary to REPEAT step 11
several times.
When starting the MOBY X for the first
time, it may be necessary to pull the
starter handle 15-20 times until it starts.
14. Once the engine has started, quickly
move the CHOKE LEVER into the RUN
(DOWN) position. (Fig. 5)
15. After engine is started, let it warm up for
2-3 minutes before riding.
Page 9 of 15