Wired remote controller (option)
For purposes of this explanation,
all parts of the display are shown
as lit. During actual operation, only
the relevant items will be lit.
Identifies the current operation
Shows the operating mode, etc.
*Multilanguage display is available.
"Centrally Controlled" indicator
Indicates that operation from the
remote controller has been prohib-
ited by a master controller.
"Timer is Off" indicator
Indicates that the timer is off.
Shows the target temperature.
Temperature setting buttons
Timer Menu button
Mode button (Return button)
Set Time buttons
Timer On/Off button
(Set Day button)
"PLEASE WAIT" message
This message is displayed for approximately 3 minutes when power is supplied to the indoor unit or when the unit is recovering from a power failure.
"NOT AVAILABLE" message
This message is displayed if an invalid button is pressed (to operate a function that the indoor unit does not have).
If a single remote controller is used to operate multiple indoor units simultaneously that are different types, this message will not be displayed as
far as any of the indoor units is equipped with the function.
Shows the current day of the week.
Shows the current time, unless the simple or Auto Off
timer is set.
If the simple or Auto Off timer is set, the time to be
switched off is shown.
TIME SUN MON TUE WED THU FRI SAT
Up/Down Air Direction indica-
shows the direc-
tion of the outcoming airflow.
"One Hour Only" indicator
Displayed if the airflow is set to
low or downward during COOL
or DRY mode. (Operation varies
according to model.)
The indicator goes off in 1 hour,
when the airflow direction
Room Temperature display
Shows the room temperature. The room
temperature display range is 8–39
The display blinks if the temperature
is less than 8
Indicates the action of the swing louver.
Does not appear if the louver is not
(Power On indicator)
Indicates that the power is on.
Built-in temperature sensor
Displayed when the remote controller
sensor is used.
Indicates that remote controller but-
tons have been locked.
"Clean The Filter" indicator
To be displayed on when it is time to
clean the filter.
The indicator comes on if the corre-
sponding timer is set.
Fan Speed indicator
Shows the selected fan speed.
Appears when the unit is running in
Fan Speed button
Test Run button
Check button (Clear button)
Airflow Up/Down button
To return operation
To go to next operation