Connections
Rewire the lens iris plug
1.
Cut off the plug of the lens cable, cut off approxi-
mately 8 mm of the insulation, and then strip
approximately 2 mm of the ends of the cable
sheaths.
8mm
2.
Solder the ends of the cable wires to the ends of
the pins, and then attach the cover of the lens iris
plug.
18
Concerning Auto-Iris Lenses
DC type auto-iris lens
A lens without driver circuit that operates only on a DC
power source. In general, this type of lens is referred to
as DC type coil lens. (Set the ALC Lens Setting Switch
to the DC position.)
CAUTION:
2mm
Depending on the type of lens used, the lens may not
perform properly.