Installation - Mounting - Heatrae Sadia SUPREME 220SS Fitting Instructions And User Manual

2.0 INSTALLATION - MOUNTING

2.1 The Supreme must be vertically wall mounted using the brackets
supplied. Special precautions may be required for the protection
of children and/or infirm persons. The appliance is not intended
for use by young children or infirm persons without supervision.
Young children should be supervised to ensure that they do not
play with the appliance.
2.2 Fig.2 details the outside dimensions of the Supreme unit. A
template is supplied to aid positioning the heater, select hole
locations according to model size. It is recommended that the
unit is positioned above a draining board. If this is not possible,
consideration should be given to any spillages that may occur
under the heater. A drip tray is available as an accessory
(Heatrae Sadia Code No. 95 970 123). The heater should be
positioned at a height to suit the items being filled (flasks, pans,
cups etc.). This is likely to position the base of the unit
approximately 250mm above the work surface.
2.3 Sufficient room should be left around the heater for access for
maintenance and servicing. The top should not be covered as
this will reduce the efficiency of the Supreme. A novel (hinged)
mounting arrangement is incorporated which can improve
access. Method detailed inside bottom access panel. Leave a
minimum of 250mm above the work surface or unit.
2.4 Ensure that the wall can support the full weight of the unit (see
TECHNICAL SPECIFICATIONS) and that there are no hidden
services (electricity, gas or water) below the surface of the wall.
2.5 Using the template mark the fixing positions and water, vent and
electricity supply entry points for your model of heater. If rear
entry services are to be used, the necessary holes for these
should be prepared prior to hanging the unit onto its bracket.
2.6 The top WALL bracket takes 10mm diameter fixings. Provide
fixings suitable for the application (use all 3 locations for
stability). The small, slotted, WALL bracket is secured in position
with the screws supplied (confirm suitability of 1 ½" x No. 12
screws and 2" plugs for use with the wall, if unsuitable due to
wall type provide alternative fixings).
5