Status Indicators; Programming - TurboChef TORNADO Service Manual

16 THE CONTROL SYSTEM
Diagnostic Display (Screen 2)
The key turns on or off the diagnostic display
DIAG
feature. When this feature is enabled, the oven will
display temperature and cook cycle parameters when
the oven is cooking or idle.
In addition, the status indicators are displayed on the
bottom of the screen. When a status indicator is
highlighted/backlit the corresponding system is off
or open. For example:
Microwave System is off.
The
STATUS INDICATOR
detailed description of each indicator.
COOKS (Screen 2)
Press once to display the total number of cook counts
for all recipes. Press again to display the total amount
of time the oven has been in cook cycles.
ACCUM (Screen 2)
Press once to display the total amount of time the
magnetrons have been on. Press again to display the
total amount of time the oven has been on.
Electronic Compartment Temperature (Screen 2)
The º
key displays the temperature inside the
ELEC
electronic compartment.
F/C (Screen 2)
Changes how the oven's temperature units are dis-
played. The /
F C
Celsius.
IR SI (Screen 2)
Displays the idle IR set point. This temperature is a
factory setting and should never be altered. If an
incorrect temperature has been entered, consult the
factory before changing this value.
W would indicate that the
section below offers a more
key alternately selects Fahrenheit or

STATUS INDICATORS

See Figures 9 and 10 on page 15.
P Primary switch – closed or open
S Secondary switch – closed or open
M Monitor switch – closed or open
t Magnetron thermostats – closed or open
h Main convection heater – off or on
i IR element – off or on
A Blower motor controller – enabled or disabled
W Microwave current – Less than or greater than 7
Amps*
* Microwave ( W ) status indicator is not
highlighted/backlit when the current is more
than 7 Amps.
Status indicators are displayed at the bottom of the
display screen when the oven is in
during normal oven operation if in
( was turned on) . Refer to Figures 9 and 10 .
DIAG
If a status indicator is highlighted/backlit, the item or
component is in an un-energized or off state.
Conversely, if a status indicator is not highlighted,
the component is in an energized or on state.

PROGRAMMING

Edit Mode
The enables the operator to manually alter
EDIT MODE
recipes and the cook cavity temperature (CCSP) .
To access :
EDIT MODE
1. Simultaneously press the
2. When prompted, enter the access code "9" and
then press the
ENTER
: If this does not provide access, refer to page 19
NOTE
for enable/disable codes.
Changing the Cook Chamber Temperature
This temperature is a factory setting - exercise caution
before altering it. For best results, consult the factory
before changing this value.
, or
TEST MODE
DIAGNOSTIC MODE
and keys.
UP DOWN
key.