Detergent Cleaning Precautions; Miscellaneous Precautions; Maintenance And Adjustment Precautions - PowerWasher RN4000 Operator's Manual

1.0 IMPORTANT SAFETY WARNINGS (cont.)
1.3

DETERGENT CLEANING PRECAUTIONS

- DO NOT use solvents or highly corrosive chemicals or acid type cleaners with this pressure washer.
NEVER spray toxic liquids or chemicals.
- DO NOT use detergents that are not compatible with the discharge hose. Read and follow the
instructions given by the detergent manufacturer.
- Keep all detergents out of reach of children and untrained adults. Proper safety precautions must be
taken before handling any chemicals.
- Read and follow all directions and instructions on the product label before using detergents.
- Wear eye protection and rubber gloves when handling or using detergents.
- Always have a clean supply of water available to wash off any contact with the skin or eyes. Should
any detergent product contact the eyes, immediately flood the eyes with clean water and seek medical
attention at once. If skin contact occurs, flood the affected area with plenty of water for 15 minutes.
If irritation persists, seek medical attention. If detergent is swallowed, follow the product label directions
and get immediate medical attentions.
- Read the material safety data sheets on all detergents before using.
- Avoid working on hot surfaces or in direct sunlight to minimize the chances of the detergent drying, which
may result in damaging painted surfaces. Be certain to clean a small section at a time.
1.4

MISCELLANEOUS PRECAUTIONS

- Read all instructions and familiarize yourself with the unit before operating.
- Read engine manual instructions completely.
- NEVER let the pump run without water flowing through unit.
- NEVER let the unit run for more than two (2) minutes with the gun in the closed position.
- NEVER leave an operating machine unattended. Always shut off the machine and relieve pressure
before leaving.
- DO NOT allow any parts of your body, clothing, or high pressure hose to make contact with the muffler.
Avoid dragging the hose over an abrasive surface such as cement. This may cause premature wear to
the hose and eventual rupturing.
- ALWAYS respect and be alert to the potential hazards of electrical equipment, hot mufflers, moving
parts, and high pressure spray.
- ALWAYS be certain that the machine safety decals are kept clean and legible. Replace any decals that
become damaged, lost or painted over.
1.5

MAINTENANCE AND ADJUSTMENT PRECAUTIONS

- Follow the maintenance instructions specified in the manual.
- NEVER alter or modify this equipment! Your personal safety as well as the safety of other persons is
at stake.
- NEVER exceed the factory pressure or temperature ratings of the system. Be sure all accessory
equipment and system components used will withstand the pressure developed.
- Use ONLY those parts and accessories recommended for these machines.
- DO NOT attempt repairs or modifications you do not understand.
- ALWAYS keep guards or shields in place. Replace any that must be removed for service or that may be
damaged.
- High pressure hoses should be inspected daily for signs of wear. If evidence of failure exists, promptly
replace all suspect hoses to prevent the possibility of injury from the high pressure spray. If a hose or
fitting is leaking, NEVER place your hand directly on the leak.
- DO NOT tamper with unloader valve adjustment or alter engine speed.
- DO NOT substitue any component parts on this machine. Use ONLY POWERWASHER replacement parts as
originally installed.
The use of incorrect parts could cause serious injury.
- Close fuel valve when transporting or storing unit.
- Check oil level in engine each time gas tank is filled.
- Keep air filter clean and engine in tune.
- Keep incoming water filter clean.
SAVE THESE INSTRUCTIONS
WWW.RONAPW.CA
page 6