Storage Precautions; Removal From Storage; Transporting - PowerWasher pwh2600 Instruction Manual

Storage Precautions

1. Change the engine oil.
2. Remove the spark plugs.
3. Pour a tablespoon (5-10 cc) of clean engine oil into the cylinder.
4. Pull the starter rope several times to distribute the oil in the cylinder.
5. Reinstall the spark plugs.
6. Pull the starter rope slowly until resistance is felt. This will close the valves so moisture
cannot enter the engine cylinder. Return the starter rope gently.
If your engine will be stored with gasoline in the fuel tank and carburetor, it is important to reduce
the hazard of gasoline vapor ignition. Select a well-ventilated storage area away from any
appliance that operates with a ame, such as a furnace, water heater, or clothes dryer. Also
avoid any area with a spark-producing electric motor, or where power tools are operated.
If possible, avoid storage areas with high humidity, because that promotes rust and corrosion.
Unless all fuel has been drained from the fuel tank, leave the fuel valve lever in the OFF position
to reduce the possibility of fuel leakage.
Position the equipment so the engine is level. Tilting can cause fuel or oil leakage.
7. With the engine and exhaust system cool, cover the engine to keep out dust. A hot engine
and exhaust system can ignite or melt some materials. Do not use sheet plastic as a dust
cover. A nonporous cover will trap moisture around the engine, promoting rust and corrosion.
If equipped with a battery for an electric starter, recharge the battery once a month while the
engine is in storage. This will help to extend the service life of the battery.

Removal from Storage

Check your engine as described in the chapter OPERATION.
If the fuel was drained during storage preparation, ll the tank with fresh gasoline. If you keep a
container of gasoline for refueling, be sure that it contains only fresh gasoline. Gasoline oxidizes
and deteriorates over time, causing hard starting.
If the cylinders were coated with oil during storage preparation, the engine may smoke brie y at
startup. This is normal.

Transporting

If the engine has been running, allow it to cool for at least 15 minutes before loading the
engine-powered equipment on the transport vehicle. A hot engine and exhaust system can burn
you and can ignite some materials.
Keep the engine level when transporting to reduce the possibility of fuel leakage. Move the fuel
valve lever to the OFF position.
32