Chapter 3: Configuring The V7122 Gateway; Assigning The V7122 Gateway Ip Address - 3Com V7122 Installation Manual

C 3: C
HAPTER
G
ATEWAY
The V7122 gateway is supplied with application software already resident in its flash memory
(with factory default parameters).
Section

Assigning the V7122 Gateway IP Address

the V7122. Section Configuring the V7122 Basic Control Protocol Parameters
to set up the V7122 gateway with basic parameters using a standard Web browser (such as
TM
Microsoft Internet Explorer).
Section Assigning the V7122 Gateway IP Address
SIP.
Assigning the V7122 Gateway IP Address
The V7122 gateway is composed of one or two identical media gateway modules. These
media gateways are fully independent, each gateway having its own MAC and IP addresses
( shows the default IP addresses of the V7122 gateway). To assign an IP address to
Table 6
each of the V7122 gateway modules use one of the following methods:
HTTP using a Web browser (see
BootP (see Assigning an IP Address Using
The embedded Command Line Interface (CLI) accessed using Telnet (see
IP Address Using the
DHCP (see the V7122 Digital Gateway User Guide).
Table 6 lists the default IP addresses of the V7122 gateway. You can use the Reset button
at any time to restore the V7122 gateway networking parameters to their factory default
values (see Restoring Networking Parameters to their Initial
V7122 Gateway Default Networking Parameters
Table 6
V7122 Gateway Version
Single module (up to 8 trunks)
Double module (up to 16 trunks)
Default subnet mask is 255.255.0.0, default gateway IP address is 0.0.0.0
V7122 Digital Gateway Installation Guide
ONFIGURING THE
Assigning an IP Address Using
BootP).
CLI).
Default Value
10.1.10.10
10.1.10.10 (Trunks 1-8) and 10.1.10.11 (Trunks 9-16)
V7122
describes how to assign IP addresses to
applies equally to H.323 and
HTTP).
State).
describes how
Assigning an
23