Note: Make sure the TeraStation's Ethernet frame size is smaller than the hub or router's. Larger frame sizes may
not transfer the data to the TeraStation correctly.
Changing the IP Address
Normally, the TeraStation's IP address is set automatically from a DHCP server on your network. If you prefer, you can
set it manually. An easy way to do this is to change it from NAS Navigator2 running on a computer connected to the
same router (subnet) as the TeraStation. The procedure to change the IP address in Settings is below.
Note: If the TeraStation is being used as an iSCSI hard drive, to change the settings, navigate to Drives - iSCSI in
Settings and move the iSCSI switch to the
1
In Settings, click Network.
2
Click
to the right of "IP Address".
temporarily before changing network settings.
156