Maintenance; Dirt Cup - Hoover Vacuum Cleaner Owner's Manual

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a sevice center prior to continuing use.
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty dirt cup.
3. Inspect and remove blockage along the dirt path. This blockage may occur at the: nozzle inlet,
nozzle connector, hose connector, hose, wand, dirt cup inlet, pre-filter, post-filter, and cyclonic
separator.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.

dirt Cup

when to empty
Empty the dirt cup at the end of each cleaning
session and before the dirt reaches the fill line.
CAUTION
!
To reduce the risk of personal injury -Unplug
before cleaning or servicing. Do not use
without dirt cup or filters in place.
Very fine materials, such as face powder or
cornstarch, may seal the filter and cause a
reduction in performance. When using the
vacuum for this type of dust, empty the cup and
clean the filters often.
How to empty
3.1 Press button on the handle located on the dirt
cup lid and pull dirt cup out.
3.2 Holding dirt cup over trash receptacle, press
dirt cup door release button to open and empty
dirt cup. When all the dirt has fallen, close the dirt
cup door and replace.
Actual model may vary from images shown.

3. MaintenanCe

NOTICE
!
3.1
!
8
!
3.2