Uniden TRAX350 User Manual page 20

How Do I Put It in My Car?
If you want to put the device somewhere other than your
windshield (or anywhere the suction cup won't stick), you can
use the anchor disk. Once you glue the anchor disk down,
the windshield mount installs inside the disk just like it does
on glass.
When you're deciding where to put the anchor disk, here are
some things to keep in mind:
The surface should be
is upside down or at a sharp angle, it might not hold the
device's weight.
The surface should be
surface texture is too rough, the glue may not stick as
well.
surfaces. If you try to remove the disk, you might
damage the surface.
Don't peel off the protective sheet until you're ready to
install the disk. Once you expose the glue, you can't stop
easily.
1) When you decide where you want to mount the disk, hold
the suction cup in that spot and set the angle and position
of the bracket (just like you would for mounting on your
windshield).
2) Clean the spot to remove any wax, grease, protecterants,
etc.
3) Carefully peel the protective sheet
from the bottom of the anchor disk to
expose the glue.
Page 20
. If the disk
. If the
on most