Info - Sharp SUPERSTEAM AX-1500JS Operation Manual

OTHER CONVENIENT FEATURES

Info

Back/Info provides 7 features and step-by-step
instructions for special functions.
MAINTENANCE
DRAIN WATER
DESCALE
STEAM CLEAN
These features can be selected by pressing Back/Info
in home page (displayed ENERGY SAVE MODE) and
then turning the Knob and pressing Enter.
DRAIN WATER
The remaining water inside the steam generator can
be evaporated by using the DRAIN WATER function.
See page 8.
DESCALE
See page 8.
STEAM CLEAN
See page 24.
CONTRAST
Contrast can adjust display darkness or brightness.
P R O C E D U R E
Press Back/Info, turn the Knob to select
1
CONTRAST and press Enter.
Turn the Knob to adjust contrast and press
2
Enter to keep the adjustment.
The contrast setting will be held in the memory
even if the oven power is off.
CHILD LOCK
Child Lock prevents unwanted oven operations by small
children. The oven can be set so that the control panel
is deactivated and locked.
P R O C E D U R E
Press Back/Info, turn the Knob to select CHILD
1
LOCK and press Enter.
2
Press Enter.
NOTES:
1. To cancel Child Lock, press Enter and hold for 3
seconds.
2. If you set Child Lock, energy save mode will be
cancelled.
3. When the oven power is off, the setting returns to
OFF.
SETTINGS
CONTRAST
CHILD LOCK
DEMO MODE
WATER HARDNESS
DEMO MODE
Cooking operations and special features can be
demonstrated with no power in the oven.
P R O C E D U R E
Press Back/Info, turn the Knob to select DEMO
1
MODE and press Enter.
Turn the Knob to select DEMO ON and press
2
Enter.
NOTE:
1. To cancel Demonstration Mode, select DEMO OFF
at step 2 or unplug the oven from the electrical outlet
and re-plug. "ENERGY SAVE MODE" will be
displayed.
2. If you set Demo Mode, energy save mode will be
cancelled.
WATER HARDNESS
Your oven is set at the factory to water hardness setting
2 (Hard). You can set the oven for the water hardness
level.
You can use the test strip supplied to check the water
hardness level.
HOW TO USE THE TEST STRIP SUPPLIED:
1. Put the test strip into the water you want to use for 1
second, then remove it.
2. Shake off excess water.
3. Wait 15 seconds, and compare colour change on
the test strip to colour chart and the table below.
When you use other test strips, follow the instructions
of them.
Hardness level Hardness range
<120 ppm
1 <120 mg/l
<6.7 °dH
120 - 250 ppm
2 120 - 250 mg/l
6.7 - 14.0 °dH
>250 ppm
3 >250 mg/l
>14.0 °dH
P R O C E D U R E
Press Back/Info, turn the Knob to select
1
WATER HARDNESS and press Enter.
Turn the Knob to select desired hardness level
2
and press Enter.
The water hardness setting will be held in the
memory even if the oven power is off.
23
Setting
Soft
Hard
Very hard