Assembly - ProMinent TZ Operating Instructions Manual

Diaphragm metering pump
Table of Contents

Advertisement

Assembly

7
Assembly
Safety notes
Supporting floor
h
P_MOZ_0016_SW
Fig. 9
20
WARNING!
Warning about personal and material damage
EX pumps only: When operating in EX areas, certain sub‐
jects must be observed.
The chapter "Important supplements for metering pumps
in EX zones" of the "General Operating Instructions on
ProMinent
®
Motor-Driven Metering Pumps and Hydraulic
Accessories" must be observed in all cases.
CAUTION!
Warning about personal and material damage
Also observe the "General Operating Instructions for ProMi‐
nent
Motor-Driven Metering Pumps and Hydraulic Accesso‐
®
ries"!
CAUTION!
Danger of environmental and material damage
The unit can be damaged or oil may escape due to incorrect
or improper storage or transportation!
The unit should only be stored or transported in a well
packaged state - preferably in its original packaging.
Only transport the unit with the locking screw - not the
bleed plug - fitted to the oil filling opening.
The packaged unit should also only be stored or trans‐
ported in accordance with the stipulated storage condi‐
tions.
The packaged unit should be protected from moisture
and the ingress of chemicals.
CAUTION!
Warning about personal and material damage
Personal and material damage may be caused if the unit is
operated outside of the permissible ambient conditions.
Please observe the permissible ambient conditions -
refer to the chapter entitled "Technical Data".
WARNING!
Risk of electric shock
If water or other electrically conducting liquids penetrate into
the drive housing, an electric shock may occur.
Position the pump so that drive housing cannot be
flooded.

Advertisement

Table of Contents
loading

This manual is also suitable for:

TzmbMakro tzMakro tzmb

Table of Contents