Storage, Transport And Unpacking - ProMinent TZ Operating Instructions Manual

4

Storage, transport and unpacking

Safety notes
Scope of delivery
Storage
WARNING!
The transporting of pumps which have been used with radio‐
active feed chemicals is forbidden!
They will also not be accepted by ProMinent!
WARNING!
Only return metering pumps for repair in a cleaned state and
with a flushed liquid end - refer to the section on decommis‐
sioning!
Only send metering pumps with a filled in Decontamination
Declaration form. The Decontamination Declaration consti‐
tutes an integral part of an inspection / repair order. A unit
can only be inspected or repaired when a Declaration of
Decontamination Form is submitted that has been completed
correctly and in full by an authorised and qualified person on
behalf of the pump operator.
You can find the "Decontamination Declaration" form under
www.prominent.com or on the CD.
CAUTION!
Danger of environmental and material damage
The unit can be damaged or oil may escape due to incorrect
or improper storage or transportation!
– The unit should only be stored or transported in a well
packaged state - preferably in its original packaging.
– Only transport the unit with the locking screw - not the
bleed plug - fitted to the oil filling opening.
– The packaged unit should also only be stored or trans‐
ported in accordance with the stipulated storage condi‐
tions.
– The packaged unit should be protected from moisture
and the ingress of chemicals.
Compare the delivery note with the shipment:
Metering pump
n
Product-specific operating instructions with EC Declaration of Con‐
n
formity
"General Operating Instructions ProMinent
n
Pumps and Hydraulic Accessories".
Personnel:
n
1. Plug the caps on the valves.
2. Check whether the seal screw is screwed into oil filler opening
instead of the vent screw.
3. Preferably place the pump standing vertically on a pallet and secure
against falling over.
4. Cover the pump with a tarpaulin cover - allowing rear ventilation.
Storage, transport and unpacking
® Motor-Driven Metering
Technical personnel
13