Well W52P User Manual page 16

User Guide W52P IP DECT Phone
AC Power
To connect the AC power:
1. Connect the DC plug on the power adapter to the DC5V port on the base station
and connect the other end of the power adapter into an electrical power outlet.
Connect the supplied Ethernet cable between the Internet port on the base station
2.
and the Internet port in your network or the switch/hub device port.
Power over Ethernet
Using a regular Ethernet cable, the base station can be powered from a PoE (IEEE
802.3af) compliant switch or hub.
To connect the PoE:
1. Connect the Ethernet cable between the Internet port on the base station and an
available port on the in-line power switch/hub.
Note If in-line power is provided, you do not need to connect the AC adapter. Make sure the
Ethernet cable and switch/hub are PoE compliant.
Important! Do not unplug or remove the power and network to the base station while it is
updating firmware and configurations.
4