Alto LYNX-MIX244 User Manual page 12

4. CONTROL ELEMENTS
after the Level control, otherwise, release the button will output the soloed
signal before the Level control.
Note: The SOLO function can never affect the mix at main recording output,
and also can't be affected by channel's MUTE switch.
30 SUBGROUPS ASSIGN TO MAIN MIX
Through these switches, you can operate the subgroup faders as a master
control for assigning the subgroups to MAIN MIX. Engage the LEFT switch to
send the corresponding subgroup signal to MAIN MIX L, and the RIGHT switch
for MAIN MIX R. When engaging the both switches, the signal will be sent to
L/R of MAIN MIX.
31 SUBGROUPS Fader
These faders are used to control the levels of the signal send to the SUB-
GROUPS OUT, the adjustable range goes from -
that is assigned to the subgroups, not muted and not turned down will be
assigned to the SUB OUTS.
32 MAIN MIX LEVEL Fader
This fader sets the amount of signal send either to the Main Mix Output or
to the Tape Output.
63 125 250 500 1K
+15
+10
+5
0
-5
-10
-15
STEREO GRAPHIC EQ
33 EQ Switch
Engage this button to add the stereo graphic EQ to the main mix output circuit.
It can be used to modify the frequency "contour" of a sound. If you release the
button, the stereo graphic EQ will be bypassed.
34 STEREO GRAPHIC EQ
Each one of these faders will boost or attenuate (+/-15 dB) the selected frequency
at a preset bandwidth. When all the faders are in the cent r position, the output
of the equalizer is flat response.
10
to +10 dB. Any channel
2K 4K 8K 16K
+15
+10
+5
0
33
-5
-10
EQ OFF
EQ ON
-15
34
e
4. CONTROL ELEMENTS
DSP SECTION
There is a powerful 24-bit/256 preset multi-effects included in your LYNX-MIX244.
Effects include reverbs, chorus, flanger, delay and combinations of the above.
37 35
35 PRESETS
Adjust this knob to select the right effect you wish to perform. There are a
total of 16 options for you: several kinds of reverb, mono and stereo delay,
effects with modulation, and versatile two-effect combination.
36 VARIATIONS
Since you have selected the preferable effect, the next step, please go with the
fine consideration, there are also a total of 16 variations for each preset, and
each variation may be managed by several different factors.
37 EFFECTS OUT Control
Rotate this knob to adjust the level of effect signal that intercepted from
internal DSP processor and directly sent to DFX OUT, which can be varied
from - to +15 dB.
38 DSP MUTE Switch & PEAK LED
This switch is used to activate/deactivate the effect facility. This LED lights up
when the input signal is too strong. In case of the digital effect module being
muted, this LED also lights up.
39 POWER LED
The LED indicates when the power is ON.
40 PHANTOM LED
This LED indicates when the phantom power is switched on.
41 MAIN MIX OUTPUT
These stereo outputs are supplied with both the XLR and 1/4" phone jacks
and it is controlled by the Main Mix Level.
36 40 38 39
11