Installing The Console Assembly - Life Fitness FTR Owner's Manual

3.4 I
NSTALLING THE
A second person, who is holding the console assembly in place, is recommended.
WARNING: Do not tip the treadmill over on its side. The base frame can swing around unexpectedly if this procedure is
not followed.
Unbuckle the strap on the top of the treadmill.
Fold the treadmill running surface up. Remove the CONSOLE ASSEMBLY (5) from under the walking belt. Fold the
treadmill running surface back down.
a) Set the console assembly into the slot on the right upright. (lower right image)
b) Connect the two electrical connectors between the LEFT UPRIGHT and the CONSOLE ASSEMBLY. Push any
excess wire into either the upright or the console assembly.
c) Set the console on top of the uprights while pushing the connectors in to the upright. The tabs on the console set
into slots on the uprights to help locate the assembly.
d) Install the four M8 X 15MM SILVER SCREWS and STAR WASHERS that hold the console to the upright. Finger
tighten the screws.
10
C A
ONSOLE SSEMBLY