Installing The Console - Life Fitness F3 Assembly & User Manual

2.4 I C
NSTALLING THE ONSOLE
Remove the pre-installed bolt (A) from the back of the
main console (B). Position the main console near the
top of the console bridge and attach the connectors
leading from the console bridge to the corresponding
tabs on the back of the main console. The wires are
color wrapped to match colored tabs on the main con-
sole circuit board. The main console harness (C)
wrapped in a green sleeve corresponds with the
green tab on the console circuit board. The Activity
Zone harness (D) wrapped in a yellow sleeve corre-
sponds with the yellow tab on the console circuit
board. The grounding wire (E) is the small green and
yellow wire that inserts onto either of the two metal
circuit board receptacles.
Be sure the connectors are fully seated together.
Feed any excess wire into the console bridge.
Attach the main console to the console bridge using
three M8 x 15mm zinc bolts (9). Tighten the bolts
securely.
CAUTION: Do not pinch the wires when attaching the main console to the console bridge.
Securely tighten all the bolts that were left finger-tight.
12