Page 2
Series subwoofers, like the D10SUB (ceiling loudspeaker) or DS8SUB (surface mount loudspeaker) are excellent complements to the DA6 when addi onal low-frequency support is desired. The DA6 is easy to install and can be used in 8-ohm mode or in 70-volt/100-volt mode for distributed systems.
Page 3
The DA6 moun ng plate has holes that match standard 1 or 2-gang electrical outlet boxes. This is a convenient way to meet local codes and bring concealed wiring to the DA6 but, by itself, moun ng to an electrical box is not usually a su cient structural moun ng system.
Page 4
Leave approximately 6” (15 cm) of speaker cable coming out of the wall at each loca on for connec on to the DA6. When the DA6 is mounted to the wall, this speaker cable will be pushed back into the wall or electrical box.
Page 5
Should it become necessary to remove the DA6 from its moun ng loca on, the loudspeaker locking mechanism must be released via the small hole on the bo om of the DA6 (Figure 4). A speci c tool is not provided for this purpose. Any simple tool, such as an Allen key or screwdriver, can be used.
Page 6
O u t d o o r U s a g e The Community DA6 is inherently weather-resistant and may be installed outdoors. To protect the connectors and wiring from corrosion, apply a small amount of silicon seal to the speaker wires as they enter the Euro connector a er making the connec ons.
Page 7
E C S TAT E M E N T O F C O N F O R M I T Y This document con rms that the range of products of Community Professional Loudspeakers bearing the CE label meets all of the requirements in the EMC direc ve 89/336/EEC laid down by the Member States Council for adjustment of legal requirements.
Page 8
11.9 lbs (5.4 kg) 17.7 lbs (8.0 kg) Shipping Weight: Community strives to improve its products on a continual basis. Specifications are therefore subject to change without notice. Community Professional Loudspeakers 333 East Fi h Street Chester, PA 19013-4511 USA TEL: 1-(610) 876-3400 FAX: 1-(610) 874-0190 www.communitypro.com...
Need help?
Do you have a question about the Distributed Design DA6 and is the answer not in the manual?
Questions and answers