Connecting The Units; Connecting The Power Terminal; Connections When Using The Speaker Input Wire - Pioneer GM-5400T Owner's Manual

SectIon
II (
Connecting the units
)
(~----~)
CD
Speaker (Left)
®
Speaker (Right)
Connecting the power
terminal
One-channeloutput
CD
Speaker (Mono)
(!)
• The use of a special red battery and ground
wire RD-223, available separately, is recom-
mended. Connect the battery wire directly
to the car battery positive terminal (f)) and
the ground wire to the car body.
~WARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.
CD
Positive
((±))
terminal
®
Engine compartment
®
Vehicle interior
®
Fuse (30 A) x 2
®
Insert the O-ring rubber grommet into the
vehicle body.
®
Drill a 14 mm hole into the vehicle body (1/2
inch) .
1 Route battery wire from engine com-
partment to the vehicle interior.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive (ffi) battery
terminal.
Connections when using
the speaker input wire
Connect the car stereo speaker output wires
to the amplifier using the supplied speaker
input wire.
• Do not connect both the RCA input and the
speaker input at the same time.
2
....-
.......
CD
CD
Car Stereo
®
Speaker output
®
Gray: Right
(±)
®
Gray/black: Right
8
®
White/black: Left
8
®
White: Left
(±)
(J) Speaker input connector
To speaker input terminal of this unit.
(!)
m
En