Connecting The Units - Pioneer GM-D9705 Owner's Manual

Class d five-channel amplifier
Table of Contents

Advertisement

C
Connecting the units
)
-
·
- - -
-~
Battery wire and ground wire size
less than 2.2 m (7ft
3
in.)
less than 3.6 m (11 ft
10in.)
less than 6.4 m (20ft
12
in.)
8AWG
6AWG
4AWG
1
Route battery wire from engine com-
partment to the vehicle interior.
When drilling a cable pass-hole into the ve-
hicle body and routing a battery wire thor-
ough it, take care not to short-circuit the
wire damaging it by the cut edges or burrs
of the hole.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive® battery term-
inal.
®
:.
\
~
,:
~~
CD
@
CD
Positive (±) terminal
®
Battery wire (sold separately)
The maximum length of the wire between
the fuse and the positive(±) terminal of the
battery is 30 cm (12 in.).
®
Fuse (100 A) (sold separately)
Each amplifier must be separately fused at
100A.
En
2
Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm (3/8 in.) of the end of
each of the wires, and then twist the ex-
posed ends of the wires.
Twist
---•
10mm
(3/8in.)
3
Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
CD
Battery wire
®
Power terminal
®
Ground wire
@ Ground terminal
®
System remote control wire
®
System remote control terminal
(J)
Terminal screws

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gm-dx975

Table of Contents