Using The Optional Remote Control; Install/Replace The Remote Control Battery - iHome iP41 User Manual

Remote not included
with all iP41
models.
To order a remote,
please visit
www.ihomeaudio.com
Install/Replace the Remote Control Battery (for models with remote control)
To order a remote control, visit www.ihomeaudio.com
The remote control battery is already installed at the factory. When the remote
control stops operating or its range seems reduced, replace the battery with a
new one.
1. The battery door is located on the back end of the unit.
2. Slide the battery door to release the battery door latch and remove the battery
door.
3. Insert a "CR2032" 3-volt lithium battery. Make sure the polarity (the + and –
side of the battery) is correct.
4. Replace the battery compartment door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Using The Optional Remote Control Unit
Power Button turns unit ON and OFF
Volume Buttons raise and lower volume on the unit.
Pressing FWD/REV while iPhone/iPod is inserted will FWD/REV to
next/previous track
Pressing and holding FWD/REV while iPhone/iPod is docked will
scan forward/reverse within currently playing track.
Pressing Play/Pause from power off mode will play iPhone/iPod.
Pressing Play/Pause while iPhone/iPod is docked and playing will pause
iPhone/iPod. Press again to resume play.
Pressing the mute button will mute the unit. While unit is muted
the volume display will flash. Pressing mute again or volume up
or down will unmute.
The up, down, fwd, rev, menu and enter buttons are used for
iPhone/iPod menu navigation
The shuffle and repeat buttons will activate/deactivate the iPhone/iPod's
shuffle and repeat modes
The snooze button works exactly same as on main unit.

Install/Replace the Remote Control Battery

7
Battery Compartment