Related Manuals for iHome iP11
Summary of Contents for iHome iP11
- Page 1 Model iP11 Alarm Clock for ® your iPhone and iPod Questions? Visit www.ihomeaudio.com...
-
Page 2: Table Of Contents
Quick Start Controls and Indicators iP11 Display Install Clock Backup Battery Setting the Clock Charging your iPhone/iPod Listening to your iPhone/iPod Listening to other portable audio devices Alarm Operation Sleep Operation Snooze/Dimmer Operation A Consumer Guide to Product Safety Trouble Shooting Solución De Problemas... - Page 3 This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules.
-
Page 4: Quick Start
DC 10V Attach AC adaptor cable to jack on back of the iP11 and plug the other end into a wall socket. NOTE: If you do not have an insert for your iPhone/iPod, please visit www.ihomeaudio.com or call iHome... -
Page 5: Controls And Indicators
Alarm Set / Alarm On/Off Button Power Off / Alarm Reset Button Snooze/Dimmer Button Back Panel Time sync/set Button DST Switch Line-in Jack Controls and Indicators Front Panel Dock -1 +1 on o line in DC 10V ... -
Page 6: Ip11 Display
Time Display The iP11 uses a CR2032 button cell backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC adaptor is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. -
Page 7: Setting The Clock
Using the Time Sync Feature The iP11 Time Sync feature allows you to sync the time setting on the iP11 to the time from your iPhone or recent model iPod (iPod Touch, iPod Nano and iPod Classic; older iPod models such as iPod mini do not support this feature). -
Page 8: Charging Your Iphone/Ipod
Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your device and the other end of the patch cord into the iP11 Line-in Jack, located on the back of the unit. -
Page 9: Alarm Operation
Note: Please make sure your iPhone/iPod has enough songs to play for one hour, otherwise please set the iPhone/iPod repeat mode to ON. Note: If there is no iPhone/iPod present or there is no music detected on the iPhone/iPod at alarm time, the iP11 will automatically switch to buzzer alarm. -
Page 10: Sleep Operation
The iP11 has an independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the alarm volume. Press the Volume + and Volume – Button on the iP11 to adjust the sleep volume. The sleep volume will remain at that level the next time you enter sleep mode until controls are changed. -
Page 11: A Consumer Guide To Product Safety
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. -
Page 12: Trouble Shooting
Please refer to your iPhone/iPod manual for details on iPhone/iPod operation. generation iPod or other device iP11 cannot control those iPods or other devices. Remove your iPhone/iPod from the connector and check for any obstruction on the connectors in the dock and on your iPhone/iPod. -
Page 13: Solución De Problemas
Verifique que su iPhone/iPod funcione correctamente antes de conectarlo a la unidad. Refiérase al manual de su iPhone/iPod para más detalles. El iP11 no puede controlar estos otros aparatos Quite el iPhone/iPod del encastre y retire la posible obstrucción del encastre o de su iPhone/iPod. -
Page 14: Warranty Information
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date of original purchase.