Related Manuals for iHome IP43
Summary of Contents for iHome IP43
- Page 1 Model iP43 FM alarm clock radio with pillow shaker Questions? Visit www.ihomeaudio.com...
-
Page 2: Table Of Contents
Quick Start ...1 Controls and Indicators ... 2-3 iP43 Display ...3 Installing/Replacing iP43 Backup Batteries / Battery Warning Setting Up the iP43 ...5 Using the iP43 Alarms...6-7 Listening to iPhone/iPod or FM Radio...7-8 Sleep mode, Dimmer and more...8 A Consumer Guide to Product Safety...9 Troubleshooting ... -
Page 3: Quick Start
Quick start 1: power RESET RESET TEST TEST Attach AC adaptor cable to DC jack on back of the iP43 and plug the other end into a working outlet. Use this insert For this iPhone / iPod 4: iPhone/ iPod... -
Page 4: Controls And Indicators
Controls and Indicators Top Panel Dock EQ Button Preset Buttons 1-6 Volume Wheel Set Wheel Alarm Reset / Power Button Play/Pause Button Radio Button Alarm 2 Button Sleep Button Alarm 1 Button Snooze/Dimmer Button Rear Panel Time Set/ Sync Button DST switch Time Zone Button DC 7.5V 2A... -
Page 5: Ip43 Display
Snooze Button PM Indicator AM Indicator Wake to Icon Sleep Mode Icon Controls and Indicators iP43 Display Time Display wake to FM Radio Indicator Line-in Plug NOTE: AM/PM indicators will not appear when clock is set to 24 hour display mode... -
Page 6: Installing/Replacing Ip43 Backup Batteries / Battery Warning
Installing/Replacing the iP43 Backup Batteries The iP43 uses “AA” LR06 batteries (pre-installed) for backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup batteries. -
Page 7: Setting Up The Ip43
Sync Time to iPhone/iPod The iP43 Time Sync feature allows you to sync the time setting on the iP43 to the time from your iPhone or recent model iPod Touch, iPod Nano and iPod Classic (older iPod models such as iPod mini do not support this feature). -
Page 8: Using The Ip43 Alarms
Using the Pillow Shaker The iP43 comes with a pillow shaker that plugs into the pillow shaker jack on the back of the unit. You can wake to any alarm mode with or without the shaker. For example, if your alarm source is set to Playlist and the pillow shaker is connected and on, the Playlist will play AND the pillow shaker will vibrate at the set alarm time. -
Page 9: Listening To Iphone/Ipod Or Fm Radio
The alarm will be silenced for the set snooze duration time then sound again. Snooze can be pressed several times during the 1 hour alarm cycle. Sure Alarm The iP43 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound in the event of a power failure. Charging your iPhone/Pod Note: Please make sure you are using the correct insert for your iPhone/iPod and that it is properly docked into the iP43. -
Page 10: Sleep Mode, Dimmer And More
1. Make sure the iP43 is OFF (not playing in any mode). Press and hold the Radio Button for about 5 seconds until “USA” appears in the lower part of display. Turn the Set Wheel to adjust country frequency to your region. -
Page 11: A Consumer Guide To Product Safety
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. -
Page 12: Troubleshooting
Possible Problem Symptom iP43 does not turn on AC adaptor isn't plugged into a working wall socket or not plugged into the power supply jack on back of the unit iP43 doesn’t respond iP43 requires a reset iPhone/iPod is not docked properly... -
Page 13: Troubleshooting
Possible Problem Symptom Sound is distorted Volume level is set too high Sound source is distorted EQ settings are too high. Unit/adaptor gets This is normal warm after extended play at high volume Snooze time Custom snooze time not set is too long/short Alarm not working AM/PM time/alarm time not set correctly... -
Page 14: Warranty Information
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date of original purchase.