Chapter 8: Troubleshooting; Forgot My Network Ip Address; Resetting Nas Ip Address And Admin Password; Can't Map A Network Drive In Windows Xp - Thecus N3200 User Manual

Chapter 8: Troubleshooting

Forgot My Network IP Address

If you forget your network IP address and have no physical access to the system,
you can find out the IP address by either looking directly onto the N3200's LCD
panel, or by using the setup wizard to retrieve the IP of your N3200.
1. Start the Setup Wizard, and it will automatically detect all Thecus IP
storage products on your network.
2. You should be able to find the IP address of the N3200 which you have
forgotten in the Device Discovery screen.

Resetting NAS IP Address and Admin Password

In case you changed the N3200 IP address and then forgot it, or forgot the
administration password, follow the steps below to reset to default settings:
1. Power on the N3200 and immediately press the Reset button for 10
seconds. (The reset button is near the LAN connector)
2. This resets the N3200 to its default IP address and password settings.
Default IP: 192.168.1.100 for WAN and 192.168.2.254 for LAN
Default admin password: admin
Jumbo Frame support: disabled

Can't Map a Network Drive in Windows XP

You may have problems mapping a network drive under the following conditions:
1. The network folder is currently mapped using a different user name and
password. To connect using a different user name and password, first
disconnect any existing mappings to this network share.
2. The mapped network drive could not be created because the following
error has occurred: Multiple connections to a server or shared
resource by the same user, using more than one user name, are
not allowed. Disconnect all previous connections to the server or shared
resource and try again.
To check out existing network connections, type net use under the DOS prompt.

Restoring Factory Defaults

From the System menu, choose the Factory Default item and the Reset to
Factory Default screen appears. Press Apply to reset the N3200 to factory
default settings.
WARNING

Problems with Time and Date Settings

The administrator is able to select an NTP Server to keep the N3200's time
synchronized. However, if the N3200 can not access the Internet, you may
encounter a problem when setting the Time and Time Zone. If this happens:
1. Login to the Web Administration Interface.
Resetting to factory defaults will not erase the data stored
WILL revert all the settings to the factory default values.
91
in the hard disks, but