High Performance Signal Band (Ap Repeater Mode) Manual - TRENDnet TEW-815DAP User Manual

TRENDnet User's Guide

High Performance Signal Band (AP Repeater mode) Manual

Wireless > Manual Wireless Setting
1. Log into your access point management page (see
management page" on page 7).
2. Click on Wireless and click on Manual Wireless Setting.
3. Configure the wireless network and security settings of the repeated signal. Click
Apply to save settings.
• Frequency Band: Select the operating wireless frequency you would like to repeat.
• Network Name (SSID): Enter the wireless network name of the signal you would
like to repeat.
• Security Mode: Select and configure the wireless security settings of the wireless
signal you would like to repeat.
4. Wait for the device to apply the settings.
5. To verify the access point has successfully copied the settings and repeated the signal
of your wireless network, wait for the Link Status to display Connected. It may take up
to 1 minute for your device to verify and display the connection status.
Note: If the Link Status does not display a Connected status after 1 min, please re-
attempt the procedure.
© Copyright 2014 TRENDnet. All Rights Reserved.
"Access your access point
• Link Status: Displays the connection status of the device either Connected or
Disconnected.
• MAC Address: Displays the MAC address of the TEW-815DAP
• Network Name (SSID): Displays the wireless network name
• Radio Band: Displays the operating wireless radio band used
• Channel Width: Display the channel width of the repeated signal
• Channel: Displays the wireless channel used
• Bit Rate: Displays the estimated connection bit rate
• Signal: Displays the connection signal strength
• Security: Displays the wireless security used.
TEW-815DAP
33