Controlling The Rest Of Your System; Operating Multiple Receivers; Setting The Remote To Control Other Components; Selecting Preset Codes Directly - Pioneer sc-9540 Operating Instructions Manual

Controlling the rest of your system

Chapter 10:
Controlling the rest of your system

Operating multiple receivers

The remote control included with this receiver can be
used to operate up to three other receivers (of the same
model as this receiver) in addition to this receiver. The
receiver to be operated is switched by inputting the
preset code to set the remote control setting.
• Set the remote modes on the receivers before using
this function (see Remote Control Mode Setup on
page 114).
INPUT
SELECT HDMI OUT
1 1 2 2 3 3
SIGNAL SEL MCACC SLEEP
4 4 5 5 6 6
SBch A.ATT DIMMER
7 7 8 8 9 9
D.ACCESS CH LEVEL CLASS
0
0
ENTER
/CLR
MASTER
INPUT VOLUME
1 Check the operation selector switch to MAIN.
2 Press RECEIVER .
3 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
4 Use the number buttons to enter the 5-digit preset
code (see below).
• Receiver 1: 6 1 9 3 5 (Default)
• Receiver 2: 6 2 6 3 0
• Receiver 3: 6 2 6 3 1
• Receiver 4: 6 2 6 3 2
The LED flashes twice when the preset code has been
properly registered. When the preset code is fully input,
the LED flashes once to indicate that the setting has
failed.
To operate another receiver, start over from step 1 to
input its preset code.
Setting the remote to control other
components
Most components can be assigned to one of the input
function buttons (such as DVD or CD) using the
component's manufacturer preset code stored in the
remote.
Note
1 You can't assign , TUNER, HOME MEDIA GALLERY, iPod USB, XM or SIRIUS.
RECEIVER
AUDIO INFO CH
DISP
RECEIVER RECEIVER
MULTI OPE TV CTRL
REMOTE REMOTE
SETUP SETUP
ZONE 2 ZONE 3
MAIN MAIN
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
If you can't find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (see Programming signals from other remote
controls on page 90).
Note
• You can cancel or exit any of the steps by pressing
. To go back a step, press RETURN.
RECEIVER
• After ten seconds of inactivity, the remote
automatically exits the operation.

Selecting preset codes directly

1 Press the input function button for the component
1
you want to control.
When assigning preset codes to TV CONTROL, press TV
CTRL here.
2 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
3 Use the number buttons to enter the 5-digit preset
code.
See Preset code list on the separate booklet.
The LED flashes twice when the preset code has been
properly registered. When the preset code is fully input,
the LED flashes once to indicate that the setting has
failed.
4 Repeat steps 1 through 3 for the other components
you want to control.
To try out the remote control, switch the component on or
off (into standby) by pressing  SOURCE. If it doesn't
seem to work, select the next code from the list (if there
is one).
10
89
en