Dimming The Display; Switching The Hdmi Output; Checking Your System Settings - Pioneer sc-9540 Operating Instructions Manual

Using other functions

Dimming the display

You can choose between four brightness levels for the
front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
SELECT HDMI OUT
1 2 3
SIGNAL SEL MCACC SLEEP
4 5 6
SBch A.ATT DIMMER DIMMER
7 8 9 9
D.ACCESS CH LEVEL CLASS
0
ENTER
/CLR
MASTER
INPUT VOLUME
RECEIVER
• Press , then press DIMMER repeatedly to
change the brightness of the front panel display.

Switching the HDMI output

Set which terminal to use when outputting video and
audio signals from the HDMI output terminals (HDMI
OUT ALL, HDMI OUT 1 or HDMI OUT 2).
The HDMI OUT1 terminal is compatible with the KURO
LINK function.
iPod USB TUNER XM SIRIUS
INPUT
SELECT HDMI OUT HDMI OUT
1 2 3 3
SIGNAL SEL MCACC SLEEP
4 5 6
SBch A.ATT DIMMER
7 8 9
RECEIVER
• Press , then press HDMI OUT.
Please wait a while when Please wait ... is displayed.
The output switches among HDMI OUT ALL, HDMI OUT 1
and HDMI OUT 2 each time the button is pressed.
Note
1 • Synchronized amp mode on page 81 is canceled when the HDMI output is switched. If you wish to use the synchronized amp mode, switch
to HDMI OUT 1, then select the synchronized amp mode on the flat panel TV using the flat panel TV's remote control.
• When the power is turned off then back on after switching the HDMI output, the input is set to a setting between HDMI1 and HDMI4, or BD.
2 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
ANT MPX PQLS MEMORY
CH
AUDIO INFO
DISP
MULTI OPE TV CTRL RECEIVER RECEIVER
REMOTE
SETUP
ZONE 2 ZONE 3
MAIN
ANT MPX PQLS MEMORY
CH
AUDIO INFO
DISP
RECEIVER RECEIVER
MULTI OPE TV CTRL
REMOTE
SETUP
ZONE 2 ZONE 3
MAIN
1

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
HDD DVD
PGM
THX PHASE CTRL
ANT MPX
AUDIO INFO
DISP
MULTI OPE TV CTRL
REMOTE
SETUP
RECEIVER
1 Press , then press STATUS to check the
system settings.
These appear on the front panel display.
The front panel display shows each of the following
settings for three seconds each:
Input Source
Sampling Frequency
Surround Back channel Processing
MCACC preset
ZONE 2 input
ZONE 3 input
KURO LINK
HDMI OUT
2 When you're finished, press STATUS again to
switch off the display.
STATUS STATUS
PQLS MEMORY
CH
RECEIVER RECEIVER
2
↓
↓
↓
↓
↓
↓
↓
09
87
en