Table of Contents
Advertisement
2.1.4
Installing Hold-down Clamps
After installing the cards on the backplane, you may want to affix hold-
down clamps to secure the cards better.
Take the several round rubber pads and clamps from the accessory box.
Choose a suitable position on the clamp shelf whereby the card can be
firmly secured. Put the round rubber pads in the holes with the clamps.
(see Fig. 2-4). Then insert the clamp and screw it in the chassis.
Warning!
Figure 2-3: Card Installation Note
Make sure the round rubber pads on the hold-down clamp
are firmly glued to the clamp. If any metal part of the clamp
contacts any card, it may cause a short circuit.
Chapter 2 AWS-8259 System Setup
15
Advertisement
Table of Contents
