Advertisement

Quick Links

AIM8IEM/AIM8Q Computer
User Manual
1

Advertisement

Table of Contents
loading

Summary of Contents for Advantech AIM8IEM

  • Page 1 AIM8IEM/AIM8Q Computer User Manual...
  • Page 2 Copyright The documentation and the software included with this product are copyrighted 2017 by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right to make improvements in the products described in this manual at any time without notice.
  • Page 3 Declaration of Conformity CE Conformity Statement Radio products with the CE alert marking comply with the R&TTE Directive (1999/5/EC) issued by the Commission of the European Community. Compliance with this directive implies conformity to the following European Norms (in brackets are the equivalent international standards).
  • Page 4 SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: M82-AIM8IEM Result for highest Simultaneous Transmission SAR value is 1.588 W/kg.
  • Page 5 IC warning statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
  • Page 6 The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.
  • Page 7 14. This product is intended to be supplied by a UL Listed Power Adapter or DC power source, rated 5.0 - 5.15 Vdc, 3A min. for model AIM8IEM, rated 9.0 – 9.1 Vdc, 2A min for model AIM8Q and Tma 50 degree C, if need further assistance,...
  • Page 8 Lithium Ion batteries may be stored at temperatures between -10°C to 60°C, however they may be depleted more rapidly at the high end of this range. It is recommended to store AIM8IEM/AIM8Q within T-W101 User Manual...
  • Page 9 Technical Support and Assistance 1. Visit the Advantech website at http://support.advantech.com where you can find the latest information about the product. 2. Contact your distributor, sales representative, or Advantech's customer service center for technical support if you need additional assistance.
  • Page 10: Table Of Contents

    1.3 Package Contents ......................13 1.4 Product Specifications ....................14 1.4.1 Technical Specifications ............14 1.4.2 Product Outlook and Dimensions ..........16 1.5 Exploring the AIM8IEM/AIM8Q ..................17 1.5.1 Front View ................1 1.5.2 Rear View ................18 1.5.3 Right View ................19 1.5.4 Left View ................
  • Page 11 4.1.2 Install applications with Android 6.0.1 ......... 30 Chapter 5 Maintenance .................... 34 5.1 Maintaining the LCD Display..................34 5.2 Cleaning the AIM8IEM/AIM8Q ..................34 5.3 Trouble Shooting ......................34 5.4 ENERGY STAR ....................... 35...
  • Page 12: Chapter 1 Introduction

    This user manual outlines all you need to know to set up and use your AIM8IEM/AIM8Q. If you have any further questions or queries, contact our technical support team via our website: http://support.advantech.com.tw/...
  • Page 13: Symbols Used In This Manual

    • Optional dock stations, including VESA/Vehicle dock & multi charger design. 1.3 Package Contents Ensure all the following items are present when you receive your AIM8IEM/AIM8Q. If any of these items are missing, contact your dealer immediately. • AIM8IEM/AIM8Q Computer •...
  • Page 14: Product Specifications

    1.4 Product Specifications 1.4.1 Technical Specifications Model Name AIM8IEM AIM8Q Intel Atom x5-Z8350 Qualcomm APQ8074 Computing Max Speed 1.44 GHz 2.2 GHz System Memory 2GB LPDDR3 Windows 10 IoT Enterprise 64 bit Android 6.0.1 32 bit On-board 32GB/64GB ( Default 32GB)
  • Page 15 x1 Power Button Hard Buttons Function x2 Volume Control Button x1 Programmable Button ( Default as BCR Trigger Key) x1 Power / Battery Status System Indicators Power Input Micro USB DC 5V, 3A DC 9V, 2A Swappable Battery with Battery Meter Capacity 3.8Vdc ;...
  • Page 16: Product Outlook And Dimensions

    1.4.2 Product Outlook and Dimensions All AIM8IEM/AIM8Q Series share the same dimension, the following illustration uses AIM8IEM as example.
  • Page 17: Exploring The Aim8Iem/Aim8Q

    1.5 Exploring the AIM8IEM/AIM8Q 1.5.1 Front View Component Front Camera Power LED Light Sensor Speaker...
  • Page 18: Rear View

    1.5.2 Rear View Component Extension Module Rear Camera with LED Flash Battery Cover...
  • Page 19: Right View

    1.5.3 Right View Component SIM & SD Card Door Programmable Key (Default BCR) Pogo Pin (USB3.0) Micro USB Door...
  • Page 20: Left View

    1.5.4 Left View Component Micro HDMI Door Power Button Volume Key UP/Down 1.5.5 Bottom View Component Audio Jack (Headset Combo)
  • Page 21: Chapter 2 Getting Started

    Chapter 2 Getting Started 2.1 Charge the Computer To charge the embedded battery in AIM8IEM/AIM8Q, connect the Micro USB adaptor on the AIM8IEM/AIM8Q computer. Micro USB Connector Please charge for at least one hour when you use this computer for the first time.
  • Page 22: Turn On The Computer

    2.2 Turn on the Computer Push the Power Button (located at no. 2 of Section 1.5.4 Left View.) for 3 seconds to start the computer. Power Button 2.3 Sleep Mode While the computer is running, push the Power Button for 1 second will move the equipment into sleep mode for power saving.
  • Page 23: Operate The Computer

    2.4 Operate the computer AIM8IEM/AIM8Q is equipped with a 8” Capacitive Touch Panel. Use finger to touch the following Active Area to operate the computer. Active Area 2.5 LED indicator status AIM8IEM/AIM8Q is equipped with one LED indicator for battery status. The following shows LED status for different power states.
  • Page 24: Chapter 3 Basic Setups

    Screens used in this manual are for illustrative purposes only. Actual screens may vary depending on your product version and pre-installed Operating System versions. AIM8IEM system power down when system battery level drops to 7%, whereas AIM8Q system power down when system battery level drops to 0%...
  • Page 25: Windows 10 Iot Enterprise Basic Setups

    3.1 Windows 10 IoT Enterprise Basic Setups Windows 10 IoT Enterprise Home Screen Function Program Launcher Battery Status Connect WLAN Adjust Audio Volume Open the On-screen keyboard...
  • Page 26: Android 6.0.1 Basic Settings

    3.2 Android 6.0.1 Basic Settings Android 6.0.1 Home Screen Function Back Home Background Applications Program Launcher...
  • Page 27 Tap top of the screen and scroll down for Settings menu Function Connect WLAN Battery Status Adjust Backlight Connect Bluetooth...
  • Page 28: Chapter 4 Running Applications

    Chapter 4 Running applications 4.1 Installing applications There are multiple ways to install applications on AIM8IEM/AIM8Q and this section shows the steps to install applications via Micro SD cards. 1. Before installation, please ensure your Micro SD card has been correctly formatted with FAT32 file system.
  • Page 29: Install Applications With Windows 10 Iot Enterprise

    4.1.1 Install applications with Windows 10 IoT Enterprise a) Go to Program Launcher b) Launch File Explorer and will find Secure Digital storage device (D:) c) Tap Secure Digital storage device (D:) to find .exe executable file. d) Tap .exe file to install the application.
  • Page 30: Install Applications With Android 6.0.1

    4.1.2 Install applications with Android 6.0.1 a) Go to Settings b) Go to Storage & USB c) Go to SD card...
  • Page 31 d) Long press the apk file and press e) Select “Downloads” “copy to…” f) Click “Copy” on the lower right corner...
  • Page 32 g) Go to “Downloads” on the menu h) Select the apk, and click Settings(first time install)
  • Page 33 i) Turn on the “Unknown sources” j) Then go back to “Downloads”, and install the apk...
  • Page 34: Chapter 5 Maintenance

    3. Power LED does not light up when DC power plug in. 4. System does not respond to touch behaviors. Contact your distributer, sales representative, or Advantech’s customer service center for technical support if you need additional assistance. Please have the following information ready before you call: Product name and serial number.
  • Page 35: Energy Star

    For more information, please visit www.energystar.gov AIM8IEM is to enter display sleep mode after 4 minutes and computer sleep mode...
  • Page 36 80% or more energy. Power Management System: Lists of default power management systems Balanced AIM8IEM: Idle 4 mins. closes screen, 10 min. enters sleep mode. (Default) AIM8Q: Idle 1 min. closes screen and enter sleep mode. High Never idle and never enters sleep mode.

This manual is also suitable for:

Aim8q

Table of Contents