Installation; Setup; Connections In Dmx Mode; Connections In Master/Slave Mode - Stairville LED Flood Panel 150 Owner's Manual

Installation

You can install the device on the wall, the ceiling or on the ground.
WARNING
Injuries caused by falling parts!
Make sure that the installation complies with the standards and rules that apply in your coun-
try.
Always secure the device with a secondary safety attachment, such as a safety cable or a
safety chain.

Setup

The required connections depend on the operation mode of the device.
Notice
Malfunction or damage to equipment!
• For failure-free operation of the DMX chain use dedicated DMX cables. Never use ordinary microphone
cables.
• Never connect the DMX output to audio devices such as mixers or amplifiers. The voltages used on the
DMX lines may severely damage the audio input circuits.

Connections in DMX mode

Connect the DMX input of the device to the DMX output socket of a DMX controller or another DMX device.
Connect the output of the first DMX device to the input of the second one, and so on to form a daisy chain.
Always ensure that the output of the last DMX device in the daisy chain is terminated with a 120-Ω resistor.
When the device is configured for DMX mode, but no DMX signal is being received, the DMX indicator flashes.
If no DMX cable is connected, the DMX indicator is constantly on.

Connections in Master/Slave mode

Connect the DMX output of the master device to the DMX input of the first slave device. Leave the DMX input
of the master device open. Then connect the DMX output of the first slave device to the DMX input of the sec-
ond slave device and so on.

DMX sockets

A female 3-pin XLR connector is used for the DMX output, a male 3-pin XLR connector for the DMX input. The
figure below and the following table show the pin assignment.
1
2 1
2
3
3
4
Ground
DMX data (–)
DMX data (+)
LED Flood Panel 150