Icom IC-V8 Instruction Manual page 45

D Setting subaudible tones for tone squelch operation
Separate tone frequencies can be set for tone squelch operation
rather than repeater operation (the same range of tones is avail-
able— see below). Like the repeater tones, these are set in set
mode.
q Select VFO or memory channel.
w Push [A•
FUNC
e Push [∫] or [√] several times until "Ct" ap-
pears when selecting CTCSS, or "dt" ap-
pears when selecting DTCS.
• " " flashes when selecting CTCSS, or " "
flashes when selecting DTCS.
r Rotate [VOL] to select the desired subaudible tone.
t Push [#•
ENT
mode.
When
SET MODE
y Push [C•
] for 1 sec. after [A•
MR
• 3 beeps are emitted.
• VFO mode is selected automatically.
u Push [C•
] for 1 sec. after [A•
MR
• 3 beeps are emitted.
Steps y and u are necessary when overwriting the memory con-
tents permanently. The set tone frequency is used for temporary
operation only, therefore,these steps are not necessary.
• Available CTCSS tone frequency list
67.0 79.7
69.3 82.5
71.9 85.4
74.4 88.5
77.0 91.5
] + [8• ] to enter set mode.
SET
] to program the selected tone and exit set
is selected from memory mode.
94.8 110.9 131.8
97.4 114.8 136.5
100.0 118.8 141.3
103.5 123.0 146.2
107.2 127.3 151.4
SUBAUDIBLE TONES
F
D
F
] is pushed.
FUNC
] is pushed.
FUNC
156.7 171.3 186.2
159.8 173.8 189.9
162.2 177.3 192.8
165.5 179.9 196.6
167.9 183.5 199.5
9
TX
MR
D TX
MR
203.5 229.1
206.5 233.6
210.7 241.8
218.1 250.3
225.7 254.1
36