Dvr Mode; Controller Mode; Setup Mode - Samsung SCC-3100A User Manual

DVR Mode

DVR MODEL Setup
This menu is for setting the DVR ID and model for
operation by a controller. Sub-controllers cannot be
used if the master controller is in Setup mode.
Press the SETUP button on the initial screen to display the
[SETUP SYSTEM] menu.
Press the 2 button to activate the [DVR SETUP] menu.
Press the 1 button to activate the [DVR Model SETUP] menu.
Press a number on the number pad to set the DVR ID.
The DVR model name saved in EEPROM will be
displayed on the LCD monitor when changing DVR ID.
Press the + and - buttons to change the DVR model name
(S-DVR SVR-1650/1640/950 SVR-440
SVR-430).
Press the ENTER button to finish the setup.
Model
• When connecting to an SVR-1650/1640/950, the SYSTEM ID must set equal to the Controller
DVR ID (Menu Network RS422/485
• When connecting the SVR-1650/1640/950 to the controller, use Port A on the left of RS422/485
SVR-1650/1640/950
located on the back side. Port B is for SPEED DOME connection. For RS485 connection, press the
TERM switches 1 & 2 down to the ON position (located next to the RS422/485 PORT).
It unifies the model of the SVR-1650/1640/950/440 with the SVR-1650.
• When connecting to an SVR-1630, the SVR-1630 keyboard control address must be set to be the
same as the controller DVR ID (Menu System Setup Misc.).
• For the SVR-1630 COM2 RS422/485 menu (Menu System Setup Serial Port), Device must be set
to SCC-3000 and Interface to RS-485, and for the COM4 RS422/485 menu (Menu System Setup
Serial Port), Device must be set to SPD2500 (if an SPD2500 is connected) and Interface to RS-485.
SVR-1630
• When controlling a PTZ camera via an SVR-1630, connect the SVR-1630 and the controller to
COM2 RX+/RXand connect the SVR-1630 and PTZ camera to COM4 RX+/RX-. Also, at the SVR-
1630 channel setup menu, set the PTZ port of each channel to COM4 and set the PTZ address to
be the same as the PTZ camera ID.
• When connecting to an SVR-430, the SVR-430 system ID must be set to be the same as the
SVR-430
controller DVR ID (Menu Network/Communication RS422/485 SYSTEM ID).
SYSTEM CONTROLLER 30
When entering '1'
SVR-1630
Contents
SYSTEM ID).
User's Manual
Model
• To connect to the SVR-5416/5116: System
check on Serial setup Communication Port 1/Equipment Number setup (Port setting must
SVR-5416/5116
be identical to controller's communication settings. Default (9600, 8, N, 1))

Controller Mode

1. Setup Mode

Press the SETUP button on the initial screen to display the
[SETUP SYSTEM] menu.
Press the 3 button to activate the [CONTROLLER
SETUP 1 ] menu.
Press the button to activate the [ CONTROLLER
SETUP 2 ] menu.
Press the button to activate the [
CONTROLLER SETUP 3] menu.
At the [CONTROLLER SETUP 1 ], [ CONTROLLER
SETUP 2 ] or [ CONTROLLER SETUP 3] menu, press a menu number to open a setup
menu.
Reference
• Press the ESC button to move to the upper setup mode.
• The Controller Setup menu can be added to enhance controller functionality.
SYSTEM CONTROLLER
Contents
Remote Controller setup Serial (RS232/RS485)
31 User's Manual