Type 7 - Pke + Xpresskit Bypass - Remote Start Ready (Rsr) + Directed Smartstart - Directed Electronics 2102T Installation Manual

Type 7 - PKE + Xpresskit Bypass - Remote Start Ready (RSR) + DIRECTED SmartStart

Connect these wires
to the vehicle.
(+) Door Sense Input: White/Purple: 4***
(-) Parking Light Output: Pink/White: 7
(-) Door Sense Input: Blue/White: 10***
Refer to the
Antenna Location
and Installation Points
section on page 5 for
more information.
Cut the unused connectors of D2D Y cable and connect
RX (blue), 12v and Ground wires to the corresponding
These wires are not required in D2D mode.
*Sold separately.
**DIRECTED SmartStart
***Door sense: The polarity of the door sense in the vehicle will determine which wire to connect
from the PKE to the DIRECTED Remote Starter.
16
See Remote Start Ready (RSR)
install guide according to your vehicle
for RSR connections details.
87
87a
86 85
30
(-) Lock Output: Green: 1
(-) Unlock Output: Blue: 2
(-) Horn Output: Red/White: 3
(+) Brake Input: Purple/Black: 5
(-) Starter Kill Output: White/Black: 6
Antenna (18 feet)
Optional
Antenna (12 feet)*
(Part# SANT-PKE12)
Antenna (8 feet)
RX: Blue: 1
3 wires red
(-) Ground: Black: 2
connector
(+) 12v: Red: 4
D2D Y CABLE
wires of the D2D cable.
DIRECTED
SmartStart
cable is sold with your SmartStart system.
TM
Starter Disable:
This connection is optional
and additional parts are
sold separately.
This toggle switch will
bypass the starter disable.
*
TM
LED
(+) 12v: Red: 4
RX: Green: 3
(-) Ground: Black: 2
TX: Blue: 1
Prog. Button
Not Used
(+)12v: Red
Ground: Black
RX: Blue
RX
(-) Ground
TX
(+)12v
© 2012 Directed� All rights reserved�
CABLE**
Not Used