Type 3A - Pke + Xpresskit Bypass + Directed Smartstart + Autostart Or Astrostart Directed Remote; Starter (With 4-Pin Antenna Connector - Directed Electronics 2102T Installation Manual

Type 3a - PKE + Xpresskit Bypass + DIRECTED SmartStart + Autostart or Astrostart
Directed Remote Starter (with 4-pin antenna connector)
Note: 8210 Antenna Universal Adapter is required and sold separately.
87
87a
86 85
30
(+) Starter Wire
Starter Disable:
This connection is
optional and ad-
ditional parts are
sold separately.
This toggle switch will
bypass the starter disable.
Refer to the
Antenna Location
and Installation Points
section on page 5 for
more information.
These wires are not required in D2D mode.
*Sold separately.
**Antenna & Antenna harness are sold with your Remote Starter kit.
***DIRECTED SmartStart
**** Door sense: The polarity of the door sense in the vehicle will determine which wire
to connect from the PKE to the DIRECTED Remote Starter.
10
(+) Ignition Output
(-) Door Sense Input****
(+) Brake Input
(+) Door Sense Input****
To The Vehicle
Regular Remote
Start Connections
(-) Horn Output: Red/White: 3
(+) Door Sense Input: White/Purple: 4****
(+) Brake Input: Purple/Black: 5
(-) Starter Kill: White/Black: 6
(-) Door Sense Input: Blue/White: 10****
Antenna (18 feet)
Antenna (12 feet)*
(Part# SANT-PKE12)
Antenna (8 feet)
RX: Blue: 1
3 wires red
(-) Ground: Black: 2
connector
(+) 12v: Red: 4
D2D Y CABLE
Cut the 4-wire red connector of D2D Y-cable and connect RX (Blue),
12v and Ground wires to the corresponding wires of the DIRECTED SmartStart
DIRECTED
SmartStart
(+) Brake Output
(-) Door Status Output
cable is sold with your DIRECTED SmartStart
TM
Antenna Harness**
Antenna**
Optional
*
TM
system.
TM
The remote starter model will
determine which connector to use.
Refer to the DIRECTED SmartStart
install guide for proper connection.
(+) 12v: Red: 4
TX: Green: 3
(-) Ground: Black: 2
RX: Blue: 1
8210*
8210 Main
Universal
Adaptor*: Refer
to the 8210 guide.
8210*
Prog. Button
Not Used
Ground: Black
cable.
TM
LED
(+) 12v: Red: 4
RX: Green: 3
(-) Ground: Black: 2
TX: Blue: 1
The connector depends
of the installed bypass.
Refer to the DIRECTED SmartStart
install guide for proper connection.
© 2012 Directed� All rights reserved�
(+)12v: Red
RX: Blue
CABLE***