Refitting The Hub Cover Bearings - Gilera Fuoco 500 Service Station Manual

Fuoco 500 i.e.

Refitting the hub cover bearings

- Heat the bearing seats on the cover using the
heat gun.
- Support the hub cover using the column kit.
Specific tooling
020151Y Air heater
020476Y Stud bolt set
- Insert the intermediate shaft bearing on the cover
using the special tool.
N.B.
PLACE IT WITH THE BALLS FACING THE HUB
(THIS APPLIES TO BEARINGS WITH PLASTIC
CAGE).
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
020363Y 20 mm guide
- Heat the gear shaft bearing seat from the cover
outside.
- Insert the gear shaft bearing on the cover using
the special punch until abutment.
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
020483Y 30 mm guide
- Replace the snap ring
Engine
ENG - 25