Removing The Wheel Axle Bearings - Gilera Fuoco 500 Service Station Manual

Fuoco 500 i.e.

Removing the wheel axle bearings

- Take out the clip on the outside of the gearbox
cover.
- Support the hub cover using the column kit.
- Pull out the bearing using the special tool.
Specific tooling
020476Y Stud bolt set
020376Y Adaptor handle
020477Y 37 mm adaptor
020483Y 30 mm guide
- Remove the oil guard using a screwdriver.
Removing the driven pulley shaft bearing
- If you have to remove the driven pulley shaft, the
relevant bearing and the oil guard, remove the
transmission cover and the clutch unit as descri-
bed in the Automatic transmission chapter.
- Extract the driven pulley shaft from its bearing.
- Remove the oil guard using a screwdriver into the
hub gear box.
- Remove the seeger ring shown in the figure.
Engine
ENG - 21