Changing The Filter Paper - Frymaster FM45E Installation & Operation Manual

5. After the oil is completely filtered, close
the drain valve and allow the fryer to refill.
When bubbles appear in the oil, allow the
filter to run 10 to 12 seconds longer to
clear the lines and prevent shortening from
hardening in them, then PUSH the filter
handle to the OFF position.
Drain Valve in
CLOSED position
WARNING
The filter motor is equipped with a
manual reset switch in case it
overheats or an electrical fault occurs.
If this switch trips, turn off power to
the filter system and allow the pump
motor to cool 40 minutes before
attempting to reset the switch.
6. Remove the Power Shower and allow it to
drain.
7. Make sure the drain valve is fully closed.
Turn the fryer ON and allow the cooking
oil/shortening to reach setpoint.
NOTE: Ensure the fryer drain valve is fully
closed before turning the fryer on. If the drain
valve is not fully closed, the controller will
display an error message or a trouble light and
the fryer will not operate.
45 SERIES GAS FRYERS
CHAPTER 4: FILTRATION INSTRUCTIONS
Filter Handle in
OFF position

CHANGING THE FILTER PAPER

Allow the filter pan to cool completely
before attempting to change the paper.
1. Slide the filter unit from the cabinet. Re-
move and clean the crumb tray.
2. Remove the hold-down ring from the filter
pan and clean.
3. Remove and discard the used filter paper.
4-4
DANGER