Solid State Basket Lift Timer - Frymaster FM45E Installation & Operation Manual

Digital
Display

SOLID STATE BASKET LIFT TIMER

The Basket Lift Timer allows the operator to
specify individual cooking times for each bas-
ket and independently control the operation of
each basket lift.
Pressing either of the ON/OFF
supplies electrical power to the fryer compo-
nents. The fryer will automatically go into the
melt cycle mode if the temperature in the fry-
pot is below 180° F (82° C), cycling on for a
few seconds and off for a longer period. The
purpose of the melt cycle is to gradually melt
solid shortening to prevent its scorching, and
to prevent the creation of "hot spots" in the
frypot. To cancel the melt cycle, press the
Right Basket button.
The cook time for each basket is continuously
shown in the Digital Displays except when the
Temperature Check
45 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
Temperature
ON/OFF
Check Button
Button
Cook Time Left
Programming Basket
Buttons Button
SOLID-STATE BASKET LIFT TIMER
buttons
buttons are pressed.
Temperature
ON/OFF
Check Button
Button
Boil-Out Right Cook Time
Button Basket Programming
Button Buttons
To change a cook time, enter the new time
using the corresponding number pad.
To view the setpoint for the frypot, press ei-
ther of the Temperature Check
The setpoint for the frypot will be shown in
the right Digital Display. To return to the
cook time display without changing the set-
point, press either of the Temperature Check
buttons again.
To change the setpoint, enter the new tem-
perature using the number pad on the right.
Press either Temperature Check
again to lock in the new setpoint and return to
the cook time mode.
NOTE: The controller automatically selects
Fahrenheit/Celsius temperature values. Val-
ues less than 190 are considered Celsius.
Pressing the Boil-Out
resets the setpoint to 195° F (91° C).
3-11
Digital
Display
buttons.
button
button temporarily
The