Setting The Cutting Depth - Chicago Electric 97200 Set Up And Operating Instructions Manual

Mini circular saw

Hide thumbs

Table Of Contents

Table of Contents

Blade

(46)

Blade

guard (37)

Hole

Cover (39)

Use both the mm and 3mm Hex Wrench to remove the Roller Pin (2) and Roller

(3).

Place the Blade on the Worm Wheel Shaft (1). Match the direction of the

rotation arrow on the Blade with the direction of the rotation arrows on the

housing.

Secure the Blade with the Roller and Roller Pin.

Replace Blade Guard and secure with the Nut and Bolt.

warning

work. it is dangerous to use this product without the Blade guard securely

attached.

When setting the cutting depth, the thickness of the material being cut should be

taken into consideration. For best results:

•

when cutting wood, set the depth of the cut to be slightly greater than the

thickness of the material.

•

when cutting plastic, set the depth of the cut to be slightly greater than the

thickness of the material. If melting occurs, a greater depth setting should

improve results.

•

when cutting metal, the depth of the cut should be set about 1mm greater

than the thickness of the material. Do not cut steel or galvanized steel. When

cutting sheet metal, allow the machine to rest three minutes for every two

minutes of work.

•

this Saw is not recommended for cutting plasterboard because the dust may

cause the Blade Guard to stick.

SKU 97200

For technical questions, please call 1-800-444-3353.

Bolt

(42)

always replace the Blade guard on the Saw before starting